60 Chain Sprocket

SSTmachinery make good qualtiy 60 chain sprocket. Material: C45, steel, stainless steel, POM. ANSI, DIN, JIS, BS, ISO standard or non standard by drawing.

Send Inquiry

Product Introduction

Parameter for 60 chain sprocket:

Pitch 19.05

Internal width 12.7

Roller 11.91

Teeth NO: 8-125

60 chain sprockets can be used for hoists:

The ring chain sprocket of the hoist refers to the chain of the ring chain hoist and the chain sprocket of the ring chain hoist. The ring chain sprocket of the hoist has the significant advantages of large conveying capacity, high lifting height of the chain hoist, stable and reliable operation and long service life in the bucket elevator, The main performance and parameters of the ring chain sprocket of the hoist comply with jb3926-85 vertical bucket elevator (the standard equivalent refers to international standards and foreign advanced standards), and the traction ring chain complies with mt36-80 mining high strength ring chain It is suitable for conveying powdery, granular and small non abrasive and small abrasive materials, such as coal, cement, stone, sand, clay, ore, etc.

Since the traction mechanism of the hoist is a circular chain, it is allowed to transport materials with high temperature (the material temperature does not exceed 250 ℃). Generally, the conveying height can be up to 40 meters TG type up to 80 meters. Bucket elevator is a continuous conveying machine that uses a series of hoppers uniformly fixed on endless traction components to vertically lift materials. It is divided into ring chain, plate chain and belt.

Notes on 60 chain sprocket processing

During the processing of sprocket, attention should be paid to the size, structure, heat treatment requirements of sprocket, final finishing method of tooth surface, product batch and other factors.

For the chain sprocket with large size and middle hole, the tooth part shall be machined on the gear machine tool.

The shaft-shaped sprocket integrated with the shaft cuts off the bar material, turns the shaft part, and then processes the tooth part on the gear machine tool.

Large sprocket, cast or made of thick steel plate by flame cutting, can also be welded into sprocket blank, and then process the teeth.

Although the sprocket processing process is different, the basic steps are the same, including blank forming, tooth forming and heat treatment.

overview