3535 Taper Lock Bushing

The taper sleeve( taper bushing 3535) pulley is actually a triangular pulley, and they can draw an equal sign, that is, basically, the taper sleeve pulley can replace any triangular pulley you use, regardless of the taper hole taper sleeve, as long as you know the inner hole. 

Compared with the synchronous belt pulley, the taper sleeve (taper bushing 3535) pulley is not so precise. It can be adjusted within a certain range to meet our selection torque. Different safety factors can be selected according to different environment and working condition coefficients. Because the taper sleeve (taper bushing 3535) pulley is a European standard, the belt type is a narrow V belt. In comparison, the imported belt can achieve twice the result with half the effort, In other words, we can improve the efficiency of the belt, and the wheels can meet the torque requirements.

Operating procedures for loading and unloading rollers

(1) Install the roller, scrub the cone sleeve and roller ring with acetone to make sure there is no water on the surface, press the cone sleeve into the roller ring, and pay attention not to press the cone sleeve onto the other end face of the roller ring, with a difference of 5 mm.

(2) check whether the inner and outer slip rings installed on the roll shaft are correctly in place.

(3) Put the combined cone sleeve and roller ring on the shaft, manually check whether the roller ring and the outer slip ring are close. If not, gently hit them with a copper bar, and then check whether the cone surface of the cone sleeve and the shaft is close. If not, gently hit them. Because the cone sleeve and the wonton ring are not interference fit, they will go down with a light hit.

(4) Put on the roller mounting tool and tighten it.

(5) First pressurize the oil nozzle of the pressure roller ring by 10 MPa, then pressurize the pressure cone nozzle by 40 MPa at most, and then stop for 20 seconds. Then take down the roller mounting tool. Note that when pressurizing the pressure cone nozzle, the oil nozzle of the pressure roller ring must be in the oil return state, otherwise the roller mounting tool will be damaged.

Hot Tags: 3535 Taper Lock Bushing, China, suppliers, manufacturers, factory, customized, wholesale, for sale, made in China