Polyurethane Round Belt Welding

SST machinery make good qualtiy polyurethane round belt. Material: PU, rubber, composite. Type:different diameter

Send Inquiry

Product Introduction

We can make Polyurethane Round Belt Welding to low down cost.

The length of the round belt is free. The belt can be cut according to the specified length, and the length of the conveyor belt can be freely selected without being bound by the specification, so as to maximize the mechanical performance of the design.

Multi shaft drive/three-dimensional drive is available, and the cross section has no directivity. Therefore, multi shaft drive can be realized, which is a three-dimensional complex drive that changes direction through idler gear.

It is convenient for installation and management. It can be installed without disassembling machinery. There are few management items such as tedious tension adjustment.

Excellent mechanical properties, using polyurethane with excellent wear resistance and tensile crack resistance.

1. What is the difference between connecting garden belt and seamless garden?

The connection has a connection port, and there is no seamless connection port.

2. What is the difference in quality between connecting circular belt（Polyurethane Round Belt Welding） and seamless circular belt?

The seamless tension is 10% better than the connecting strip, and there is no risk of fracture of the connecting port.

3. Cold adhesive or non adhesive when connecting polyester belt?

They are generally hot and sticky.

4. What is the shortest connecting length of the connecting round belt（Polyurethane Round Belt Welding）?

The shortest connection perimeter of the fixture is 300mm, which is suitable for products with a diameter of 8mm and below. The shortest connection perimeter with a diameter of 10mm is 400mm, and those with a diameter greater than 10mm are not recommended to be connected into short strips.

5. What are the differences between the connection process of cored polyester belt and coreless polyester belt?

The connection process is basically the same, but pay attention not to burn and melt too much of the welding surface, which will lead to too much extension of the rope core inside, which may affect the quality of the connection.

overview