Knowledge

1、 Clean before assembly. 2、 The center line of the driving sprocket and the driven sprocket shall coincide, and the deviation shall not be greater than 2/1000 of the center distan

1. The tightness of the sprocket should be adjusted reasonably. Too tight will increase power consumption and cause bearing wear; Too loose will cause the sprocket to jump and drag

1. Driving sprocket The driving sprocket is combined with the engine output shaft in the form of splines and fixed with spline baffle or nuts. As part of sprocket drive. 2. Driven

First, group sprockets should be fully engaged, which is very important. Only if it is fully engaged, it will not increase the wear rate of sprockets. Second, the tightness of the

1、 Stainless steel chain: the material of the parts is stainless steel. This kind of chain is suitable for use in the food industry and occasions prone to chemical and drug erosion

装配前应清洗洁净。 主动链轮与被动链轮齿的中心线应重合，其偏差不得大于两链轮中心距的２ / １０００。 链条工作边拉紧时，非工作边的弛垂度ｆ（见下图）应符合设计规定。当无规定且链条与水平线夹角α小于６０°时，可按两链轮中心距Ｌ的１％～４ . ５％调整。

1. The tightness of the sprocket should be adjusted reasonably. Too tight will increase power consumption and cause bearing wear; Too loose will cause the sprocket to jump and drag

SSTmachinery make good quality chain and sprocket

By name: stainless steel chain plate, conveyor chain plate, metal conveyor chain plate, stainless steel conveyor chain plate, metal conveyor chain plate, stainless steel transmissi

The tightness of the transmission chain should not be too tight or too loose, which will damage the transmission chain. 1. Chloride ions do great harm to stainless steel plate spro

Product specification: GB series: AV10、AV13、AV15、AV17、AV22 SAE standard series 10A、11A、13A、15A、17A、20A Japanese Jaso standard series: V10、V13、V15 Automobile combined V-belt: 2/AV15

This belt is an upgraded version of the industrial trimming V-belt and has the following features: Product advantages ① The ultra wide ambient temperature enables the belt to be us